The way these work is that the furniture bolt goes through pre-drilled holes in your post and the end of your side rail, and is held in place by going through the barrel nut which has been inserted into the rail. The concept is fairly simple, but it will require a fair amount of precision in execution. Barrel nuts and furniture boltsīarrel nuts and furniture bolts are what you might be used to seeing if you’ve ever put together any Ikea furniture. The hole from the forstner bit should allow you to slip on the washer and nut, and tighten the bolt down as needed. Then drill an intersecting hole through the headboard post and into the center of the end of the side rail slightly larger in diameter than your bolts. If you are drilling into a 3/4″ thick side rail, simply ensure to not drill down farther than 5/8″ with the tip of the bit (since it protrudes past the face). Well, you might ask if you are putting the nut into the end of the side rail how do you get to the other side? Simple, you drill a hole not quite all the way through your side rail using a forstner bit.įorstner bits are designed to create holes with flat bottoms, so it’s ideal in this application. The first option for using bolts is to simply use a washer and nut on the other side. Bolts (there are several options using bolts) Simple bolts, with washer and nut Instead, I’d recommend using any one of the below methods that uses metal on metal connections. Over time, the joint can give way and become loose and even fail – particularly if you move the bed more than once. Why? Well because since you are screwing into wood with a metal screw, every time you insert and then remove that screw you are weakening the wood which is supposed to be holding it in place. This is definitely an easy and common solution, and I’m ok with the idea of using pocket hole screws in a lot of applications – this just doesn’t happen to be one of them. This involves drilling several holes at a preset angle into the end of the rail so that pocket hole screws can then be driven through those holes and into the headboard posts. The most common method these days is probably using a Kreg jig to make simple pocket holes. So what can you do? What are your options? Well I’ll cover a few of the more popular options below and most of these options are easier than you think! Pocket hole screws So you can’t use typical wood joinery to connect the side rails to the headboard and footboard, otherwise you’ll never get them apart again. If you’ve ever thought about, or have actually tried building your own bed frame, inevitably one of the questions that comes up is “how do I attach the side rails to the headboard and footboard?” Bed frames are large and cumbersome, and obviously have to be moved around the house in separate pieces.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |